*****     WARNING *****
 
If your system DOES NOT POWER UP, you have NOT installed your coprocessor
correctly. TURN OFF THE POWER IMMEDIATELY!



The FasMath Processor and Demonstration Software are designed to run in
an 80386 system only!  The demonstration software will not run on an 80287.



If your system passes its memory test but will not boot, you may have to
set switches in your computer or run a configuration utility to configure
your system for the numerics processor. Refer to your computers users 
manual for further details.




                 Press <enter> to continue.



            FasMath Demonstration Software Installation

TO INSTALL FASMATH DEMONSTRATION SOFTWARE ON TO YOUR HARDDISK or RAMDISK
         WITH THE DEMONSTRATION DISK INSTALLED IN FLOPPY DRIVE A.

I) Change the default drive to your Harddisk or RAMdisk by typing:

	c: <enter>  Where c is the letter of the new drive.

II) Create a directory called FasMath by typing

	MD \FASMATH <enter>

III) Change directory to FasMath by typing

	CD \FASMATH  <enter>

IV) Copy demonstration files from floppy disk to Harddisk or RAMdisk

	COPY A:.  <enter>   [NOTE: type the period (.) after the colon]


               Press <enter> to continue.

V) Run FasMath demonstrations by typing

	FASMATH <enter>




NOTE:  The FasMath demonstration diskette contains a file called
       GLOSSARY.TXT which defines some of the terms used in the
       demonstration. To print the glossary type:

			PRINT GLOSSARY.TXT <enter>




FasMath is a registered trade mark of Cyrix Corp.