Valid SCSI Error Codes & Meanings * Sense Code Definitions SNOSENSE: EQU 00H No Sense SRECOVER: EQU 01H Recovered Error SNOTRDY: EQU 02H Not Ready SMEDIUM: EQU 03H Medium Error SHARD: EQU 04H Hardware Error SILLEGAL: EQU 05H Illegal Request SUNITATN: EQU 06H Unit Attention SDATAPRO: EQU 07H Data Protect SBLANK: EQU 08H Blank Check SCOPYABO: EQU 0AH Copy Aborted SABORTED: EQU 0BH Aborted Command SEQUAL: EQU 0CH Equal SVOLOVER: EQU 0DH Volume Overflow SMISCOMP: EQU 0EH Miscompare * Additional Sense Code Definitions * Valid Sense data EVALSENS: EQU 7 * Sense Key NO SENSE (00H) ENOSENSE: EQU 00H No Additional Sense Information * Sense Key RECOVERED ERROR (01H) ERETRIES: EQU 17H Recovered Read Data with Retries EECC: EQU 18H Recovered Read Data with ECC Correction EDEFECT: EQU 19H Defect List Error EPRIMARY: EQU 1CH Primary Defect List Not Found EID: EQU 1EH Recovered ID Read with ECC Correction EROUND: EQU 37H Rounded Parameter ENODEF: EQU 3DH Defect List Not Available * Sense Key NOT READY (02H) EREADY: EQU 04H Drive Not Ready (Off Line) ESELECT: EQU 05H Drive Not Selected ENOTCONF: EQU 3EH Logical Unit has not Self-Configured * Sense Key MEDIUM ERROR (03H) EREAD: EQU 11H Unrecovered Read Error EIDMARK: EQU 12H No Address Mark Found in ID Field EDATMARK: EQU 13H No Address Mark Found in Data Field ERNF: EQU 14H Record Not Found EDATSYNC: EQU 16H Data Sync Mark Error *EPRIMARY:EQU 1CH Primary Defect List Not Found ECARTRIG: EQU 30H Incompatible Cartridge EFORMCOR: EQU 31H Medium Format Corrupted ENOSPARE: EQU 32H No Defect Space Location Available ENODL: EQU 3DH Defect List Not Available * * Sense Key HARDWARE ERROR (04H) ENOSECT: EQU 01H No Index / Sector Signal ENOSC: EQU 02H No Seek Complete EWRFAULT: EQU 03H Write Fault ETRACK0: EQU 06H No Track Zero Found EMULTSEL: EQU 07H Multiple Drives Selected ELUNCOMM: EQU 08H Logical Unit Communication Failure ETRACKER: EQU 09H Track Following Error EIDCHECK: EQU 10H ID CRC or ECC Error ESEEK: EQU 15H Seek Positioning Error EDEFLIST: EQU 19H Defect List Error ESYNCXFR: EQU 1BH Synchronous Transfer Error *EPRIMARY:EQU 1CH Primary Defect List Not Found *ECARTRIG:EQU 30H Incompatible Cartridge *EFORMCOR:EQU 31H Medium Format Corrupted *ENOSPARE:EQU 32H No Defect Space Location Available *ENODL: EQU 3DH Defect List Not Available ERAM: EQU 40H RAM Failure EDATPATH: EQU 41H Data Path Diagnostic Failure EPOWERON: EQU 42H Power On Failure ECONTROL: EQU 44H Internal Controller Error ESELFAIL: EQU 45H Select / Reselect Failure EBADRES: EQU 46H Unsuccessful Soft RESET ESELFCON: EQU 4CH Logical Unit Failed Self-Configuration * Sense Key ILLEGAL REQUEST (05H) EPAROVER: EQU 1AH Parameter Overrun ECDB: EQU 20H Invalid Command Operation Code ELBA: EQU 21H Illegal Logical Block Address EFUNCT: EQU 22H Illegal Function ECFIELD: EQU 24H Illegal Field in CDB ELUN: EQU 25H Invalid LUN EDFIELD: EQU 26H Invalid Field in Parameter List ENODISC: EQU 2BH Copy Illegal because Host can't disconnect ECDMSEQ: EQU 2CH Command Sequence Error ENOSAVE: EQU 39H Save Parameters Not Supported ENOLINK: EQU 3CH Link Flag Bit Not Supported * Sense Key UNIT ATTENTION (06H) EMEDIUM: EQU 28H Medium Changed (Ready went true) ERESET: EQU 29H Power On or RESET occurred EMODESEL: EQU 2AH Mode Select Parameters Changed EMICRO: EQU 3FH Microcode has been downloaded * Sense Key DATA PROTECT (07H) EWRTPRO: EQU 27H Write Protected * Sense Key COPY ABORTED (0AH) ECOPYERR: EQU 60H Status Error from second party Copy command * * Sense Key ABORTED COMMAND (0BH) EMSGRTY: EQU 43H Unseccessful Message Retry EPE: EQU 47H Interface Parity Error EINITERR: EQU 48H Initiator Detected Error EMSGOUT: EQU 49H Message Out Error EDATAERR: EQU 4BH Data Error * Sense Key MISCOMPARE (0EH) EMISCOMP: EQU 1DH Compare Error (Write or Write/Verify)