For use with FWKCS(TM) Contents_Signature System, Version 1.12.
(C)Copyright Frederick W. Kantor 1991. All rights reserved.

         (Detailed setup instructions are available in SETUP.112,
         contained in FWKCS112.ZIP. There is not enough space on a
         "360K" floppy for that file to fit in uncompressed form with
         everything else.)

To install the FWKCS(TM) Contents_Signature System:

1. If you received this on a floppy disc, the disc should contain
README.TXT (this document), CONTENTS.112, REGISTER.DOC, GO.BAT, and
FWKCS112.ZIP.  With Phil Katz's PKUNZIP(R) and Ben Baker's QSORT
version 3.20 available on your PATH, under IBM/MS DOS 3.30-5.00, with
at least 10% of your hard drive available as free space, put the disk
into one of your floppy drives, and go to step 3.

2. If you downloaded this from an electronic bulletin board system,
then, working on your hard drive with at least 10% free space, first do

               PKUNZIP FWKCS112  GO.BAT <enter>

then go to step 3.

3.  Run        GO <enter>

It will tell you what you need to do. In must cases, installation takes
only a few key_strokes on your part, after which the program does the
installation automatically.

If you need them, you have the option of using powerful string_search
capabilities -- for example, for installation on more complicated 
computer configurations, where certain classes of files are kept open 
and must be skipped.

    After FWKCS is installed, there are two on_line help menus,

         CSM.BAT, in the \cs subdirectory,

    and

         CSAM.BAT, in the \csa subdirectory,

    to help you with the special .BAT and .COM programs and literature.